Standard functions
6
Logamatic 4323 - Subject to technical modifications.
25
6.5.1 Setting the DHW temperature
You can change the DHW temperature as follows:
Hold down the "DHW" key, and select the required DHW temperature with
the
rotary selector.
Release the "DHW" key. The newly selected DHW temperature is saved within
approx. 2
seconds. The permanent display will then appear again.
WARNING!
RISK OF SCALDING
The DHW cylinder temperature is preset to 60 °C. There is a risk of scalding
from hot water if your installer has set the DHW temperature higher or has
activated the "Therm. disinfect" function, and the heating water circuit of your
heating system is not equipped with a thermostatically controlled mixer.
Please note that fittings too can get very hot.
z In such cases, only ever draw off mixed water (hot and cold).
USER NOTE
For thermal disinfection, the DHW will be heated to at least 60 °C once or twice
per week to kill off possible bacteria (e.g. legionnella).
To Next Page
Loading...
