Buderus Logamatic 4323 - Page 40

Extended functions
7
Logamatic 4323 - Subject to technical modifications.
40
Hold down "Time", and select the required time with the rotary selector,
e.g.: "06:30".
Release the "Time" key. The newly adjusted time for the "ON" switching point
is
now saved.
The modified switching point will be saved under the "Own" program and the
number of the heating circuit (here: "2").
Continue to turn the rotary selector, until the next switching point that you want
to change is displayed.
The "OFF" switching point for Monday appears. Now you can modify the time for
the "OFF" switching point.
Hold down "Time", and select the required time with the rotary selector,
e.g.: "23:00".
Release the "Time" key. The newly adjusted time for the "OFF" switching point
is saved.
Next switching point
Continue to turn the rotary selector until the next switching point is displayed.
The next switching point (Tuesday, 05:30) appears.
Also change the following switching points to 06:30 and 23:00. The system will
now heat from 06:30 to 23:00 Monday to Thursday.
Press "Back" to return to the permanent display.
The modified standard program is saved under "Own" and the number of the
heating circuit.
+
Own program 2
Monday
21°C
at 06:30
+
USER NOTE
You can change the weekday if you press "Weekday" instead of "Time".
You can change the switching state ("ON"/"OFF") by pressing "Display"
instead of "Weekday" or "Time". The operating mode determines the switching
state: "ON" = day mode, "OFF" = night mode.
z Ensure that a stop point is associated with every start point.