Buffalo WCR-GN - Forgot SSID, Encryption Key, or Password; Slow Wireless Link Speed; Other Tips

WCR-GN User Manual 86
Chapter 6 Trouble Shooting
The following are the factory default settings of the AirStation:
 SSID-   PrintedonthelabeloftheAirStation
Encryption Method - No Authenticate
 EncryptionKey- NoEncryption
• PlaceyourAirStationandwirelessdevices2-10feetapart.
• RestartyourAirStation.
You forgot AirStation's SSID, Encryption Key, or
Password.
HolddowntheRESETbutton(page99)onyourAirStationfor5secondstoinitializeitssettings.All
settings,includingyourpassword,SSID,andencryptionkeywillbeinitializedtotheirdefaults.
The followings are the factory default settings of the AirStation.
 SSID-   PrintedonthelabeloftheAirStation
Encryption Method - No Authenticate
 EncryptionKey- NoEncryption
The link speed is slower than 150 Mbps (Maximum
link speed is only 72Mbps).
By default, the AirStation’s 150 Mbps mode is not enabled. To enable it, use the following procedure:
 1. OpenthecongurationscreenofyourAirStation(page23).
 2. Click"Wireless SSID & Channel (11n 150Mbps Mode)"inEasySetup.
 3. Changethevaluein"150 Mbps Mode"-"Band Width"to40MHzandclick"Apply".
Ifyoustillcannotconnectat150Mbps,checkthesettingsofyourwirelessclientdevice.
Other Tips