Buffalo WCR-GN - Windows Vista TCP;IP Configuration

Appendix C TCP/IP Settings in Windows
WCR-GN User Manual 97
1
ClickStart>Control Panel.
2
Doubleclick“Network and Sharing Center”.
3
Click“Manage network connections” on the left side menu.
4
Rightclickon“Local Area Connection”,thenclick“Properties”.
5
Whenthemessage“Windows needs your permission to continue” appears,click“Continue”.
6
Select“Internet Protocol Version 4 (TCP/IPv4)”thenclick“Properties”.
7
Select“Obtain an IP address automatically”and“Obtain DNS server address automatically”, then
click“OK” in normal situations.
 IfyouxtheIPaddress,enterthevalueasnecessary.
 ex) Iftherouter'sIPaddressis192.168.11.1,
   IPaddress 192.168.11.80
Subnet mask 255.255.255.0
Default gateway blank
Preferred DNS server blank
Alternate DNS server blank
8
Click“Close”.
Windows Vista
ToperformthesettingsforWindowsVista,followtheprocedurebelow.