31
Installation
Type 3280, 3285
Closing the actuator cover
NOTE!
Damage or malfunction due to ingress of dirt and moisture!
• To guarantee protection class IP, ensure that the actuator housing has been installed correctly.
Do not clamp any loose cables!
Position of the cable
Figure 20: Correct position of the cable
→ Carefully attach actuator cover.
→ Manually insert 4 screws into the designated holes on the lower side of the actuator housing, Type 3280, or
on the upper side of the actuator cover, Type 3285, and turn them onto the first thread.
→ Tighten screws (tightening torque: 2 Nm).
To Next Page
Loading...
