Burkert 8045 - Description of the Navigation Keys and the Status LEDs

29
Operating and functions
8.3. Description of the navigation keys and the status
LEDs
• Selecting the displayed
parameter
• Confirming the settings
Status LED of relay DO3 (LED ON
= contact closed)
• Reading the messages
• Scrolling through the parameters
• Selecting the figure on the left
• Scrolling up the
parameters
• increment the figure
selected
Device status LED: see
following table.
Status LED of relay DO2 (LED ON
= contact closed)
Device status
LED
Status of the device
Green The device operates correctly.
Orange
A warning message is generated.
→ Press the key for 2 seconds in the Process level to access the message. See chap.
“9.5.5” for the meaning of the message.
Furthermore, a relay output (DO2 or DO3) or the transistor output DO1 switches if it is
configured in the "WARNING" mode (see Fig. 39 or Fig. 42)
Red
A fault message is generated and a 22 mA current is sent on the current output.
→ Press the key for 2 seconds in the Process level to access the message. See chap.
“9.5.4” for the meaning of the message.
Blinking,
whatever the
colour
• the DI1 digital input is active,
• or a check for the correct behaviour of the outputs is running (see chap. “8.7.3”)
• or a flow zero point calibration procedure is running (see chap. “8.7.2”),
• or the daily totalizer is kept at zero.
English
Type 8045