Burkert 8045 - Configuring the Transistor Output DO1 to Switch a Load When a Warning Message Is Emitted by the Device; 8.6.11. Configuring the Do2 and Do3 Relay Outputs

43
Operating and functions
8.6.10. Configuring the transistor output DO1 to switch a load
when a warning message is emitted by the device
When the device generates a warning message, the device status LED is orange.
The generation of a warning message can also be indicated by the switching of the transistor output.
REtURN
On a version WITH relay out-
puts
On a version WITHOUT relay
outputs
OUtPUt DO1 wARNiNG
DO2
iNV YEs
iNV NO
0......9
→ Choose the operating, inverted or not inverted, of the
transistor output.
DEL. 1= 00
→ Enter the time delay before switching value (value
between 0 and 99 s).
→ Confirm.
Fig. 39: Configuration of the DO1 transistor output to indicate the generation of a warning message
8.6.11. Configuring the DO2 and DO3 relay outputs
Any DO relay output can be configured either:
• to switch a load depending on two thresholds. See “Fig. 36”, chap. “8.6.7” and “Fig. 40”.
• to switch a load to indicate the fluid circulation changes. See “Fig. 41”.
• to switch a load when a warning message is generated by the device. See “Fig. 42”.
English
Type 8045