Burkert 8045 User Manual

30
Operating and functions
8.4. Using the navigation keys
You want to... Press...
move between parameters within a level or a menu.
•
to go the next parameter.
•
0......9
to go to the previous parameter.
access the Parameters menu
ENTER
+ simultaneously for 5 s, in the Process level
access the Test menu.
0......9
+ +
ENTER
simultaneously for 5 s, in the Process
level
access the Information menu.
for 2 s, in the Process level, when the device status
LED is orange or red.
reset the daily totalizer.
0......9
+ simultaneously for 2 s, when the daily totalizer
is displayed in the Process level
select the displayed parameter.
ENTER
confirm the displayed value.
ENTER
modify a numerical value.
•
0......9
to increase the blinking digit.
• to select the digit at the left of the blinking digit.
•
0......9
+ to move the decimal point.
8.5. Details of the Process level
This level is active by default when the device is energized.
12.6 L/s
16.45 mA
87654 L
231 L.
0......9
> 2 s
Resetting the daily totalizer.
Value of the measured flow rate, displayed in the unit chosen in the "UNIT" parameter
of the Parameters menu.
Value of the current output, proportional to the measured flow rate.
Value of the main totalizer, volume of fluid counted by the device since the last reset.
Value of the daily totalizer (identified by a dot after the volume units), volume of fluid
counted by the device since the last reset.
0......9
+
0 L/s.
The displayed flow rate is set to 0 (a dot is displayed after the
flow rate units if the "CUT-OFF" function is active) because
the measured flow rate is below the threshold value defined in
the "CUT-OFF" parameter of the Parameters menu. See chap.
“8.6.16”.
or
English
Type 8045

Burkert 8045 Specifications

General

Brand	Burkert
Model	8045
Category	Transmitter
Language	English