60
Maintenance and troubleshooting
9. MAINTENANCE AND TROUBLESHOOTING
9.1. Safety instructions
danger
Risk of injury due to high pressure in the installation.
• Stop the circulation of fluid, cut off the pressure and drain the pipe before loosening the process connections.
Risk of injury due to electrical voltage.
• Shut down the electrical power source of all the conductors and isolate it before carrying out work on the
system.
• Observe all applicable accident protection and safety regulations for electrical equipment.
Risk of injury due to high fluid temperatures.
• Use safety gloves to handle the device.
• Stop the circulation of fluid and drain the pipe before loosening the process connections.
Risk of injury due to the nature of the fluid.
• Respect the prevailing regulations on accident prevention and safety relating to the use of aggressive fluids.
Warning
Risk of injury due to non-conforming maintenance.
• Maintenance must only be carried out by qualified and skilled staff with the appropriate tools.
• Ensure that the restart of the installation is controlled after any interventions.
9.2. Cleaning the device
The 8045 flowmeter can be cleaned with a cloth dampened with water or a detergent compatible with the mate-
rials the device is made of.
Please feel free to contact your Bürkert supplier for any additional information..
9.3. Cleaning the flow sensor
note
• use a cleaning product that is compatible with the materials the flow sensor is made of.
• Do not use any abrasive acting materials.
English
Type 8045
To Next Page
Loading...
Need help?
General
