OPERATING THE DEVICE
18
O D
►
Before switching the integrated amplifier on, check all cable connections for correct
polarity (POS, NEG). After initial or re-wiring, we recommend slowly increasing the
volume until you are certain that everything is connected correctly.
Power on/off
The device is equipped with two control elements for power on/off:
• The power switch (15) is located on the back side of the device. Actuating the power
switch connects/disconnects the standby transformer to/from the power supply.
• The power on/off switch (8) is located on the front side of the device. Actuating the
power on/off switch switches the device between standby mode, operating mode,
and OFF.
►
Before switching the integrated amplifier on, turn down the volume; do not increase
the volume until after you have switched the device on.
Switching the device to standby mode when it is off:
1. Set the mains switch on the back side of the device to ON.
The standby transformer is connected to the power supply.
2. Set the power on/off switch(8) on the front side into the center position, STBY.
The device switches into standby mode and the operation LED (9) lights up in
orange.
Switching the device on from standby mode:
►
Briefly push the power on/off switch (8) upward into the ON position or press the
POWER (24) button on the remote control.
The device switches into standby mode and the operation LED (9) lights up in
red.
After switching the device on, the monitoring electronics take a few seconds to
perform a complete check of the integrated amplifier. If no errors are present, the
speaker outputs are then enabled.
NOTE: The pre-out only mode is an exception. In this mode, the 101 is switched on, but the
power amp is not. For more information, please see „Pre-out only mode“ on page21.
Switching the device from operation into standby mode:
►
Briefly push the power on/off switch (8) upward into the ON position or press the
POWER (24) button on the remote control.
The device switches into standby mode and the operation LED (9) lights up in
orange.
The power switch (15) can remain in the ON position. Thus, you can conveniently
control the device using the power on/off switch (8), or the remote control. As only the
standby transformer is active during standby mode, minimum electricity is consumed.
Switching off the device with the power on/off switch:
►
Move the power on/off switch (8) downward into the OFF position.
The device is switched off and cannot be switched back on with the remote
control. The operation LED (9) goes out.
To Next Page
Loading...
