OPERATING THE DEVICE
101 Integrated Amplifier
19
Switching the device off completely:
During longer periods of absence or if the device is not in use and thus should not
consume any electricity, you can turn it off completely using the mains switch. Once it is
off, you can no longer switch it back on with the remote control.
1. Turn off the device with the power on/off switch (8).
2. Set the mains switch (15) to OFF.
NOTE: Always turn off the device with the power on/off switch before setting the mains switch
to OFF.
ATTENTION
Overvoltages caused by lightning
Overvoltages in the power supply – caused by lightning – can damage or destroy the
device.
►
When a storm is approaching, disconnect the power plug from the outlet.
Turning the system off with the power switch is not enough, as overvoltages “jump”
across contacts even if they are not closed.
Selecting a signal source
The input source can be selected using the input selection buttons (1) or the remote
control.
►
Press the desired input selection button to choose the signal source.
The selected input is indicated by means of an LED (6).
Adjusting the volume
CAUTION
High-intensity sound
Loud output signals can cause permanent damage to your hearing.
►
Set the volume to a low level using the volume control (5) and adjust it slowly to
the desired volume.
►
Avoid listening to loud music for prolonged periods of time.
The volume can be adjusted using the volume control (5) or the remote control
(VOL+/VOL–).
►
Turn the volume control clockwise to increase the volume.
►
Turn the volume control counterclockwise to reduce the volume.
To Next Page
Loading...
