IMPORTANT SAFETY INFORMATION
101 Integrated Amplifier
7
I S I
Please read through the device operating instructions completely and save them.
Should you have any questions, please contact your specialist dealer.
Unpacking
An operating temperature that is too low or too high may lead to errors in the device.
For this reason, after unpacking the device, leave it standing for some time before
connecting it and turning it on.
The device is delivered packaged in a plastic bag. Keep this bag out of reach of
children to prevent a choking hazard.
Set-up
When selecting an installation location, please note the following:
• Avoid direct sunlight.
• Avoid excessive heat, cold, humidity, and dust.
• Ensure sufficient ventilation. Do not place the device in a closed rack.
• Slots and openings on the device serve as a means of ventilation. They must not be
covered.
• Do not expose the device to dripping water or spray water and do not place any
containers holding liquids on your device.
• Do not place any open ignition sources, such as burning candles, on the device.
Connecting
Use only the supplied 3-wire power cord for power supply. The protective earth contact
must not be rendered ineffective. Connect the device only to an outlet with a
functioning protective conductor connection.
Connectors
Do not touch the pins in the connectors on the back side of the device with your
fingers. Static discharges may damage the electronics inside the device.
Connection cables
Burmester produces symmetric and asymmetric connection cables, as well as speaker
cables in all lengths to transmit the best possible sound quality. The impedance of our
cables is adapted for all BURMESTER components.
For optimal power supply, we recommend our triple shielded BURMESTER POWER
power cord.
To Next Page
Loading...
