Burnham Revolution - Burnham Gasketed Vent Joint Detail; Burnham Gasket-Less Vent Joint Detail; Install Vent Pipe, Burnham Gasketed Vent System; Install Vent Pipe, Burnham Gasket-Less Vent System

12
C. Install Vent Pipe, Burnham Gasket-Less Vent System.
1. Procedure for Joining Burnham Gasket-Less Vent Pipe and Fittings. See Figure 3A.
Figure 3A: Burnham Gasket-Less Vent Joint Detail
Figure 3B: Burnham Gasketed Vent Joint Detail
a. Cleanjointsofpipeorttingsusinganalcoholpadtoremoveanydirtandgrease.
b. Slipalockingbandoverfemale(bell)endofpipe/tting.
c. Apply a continuous ¼ inch bead of sealant around male end of joint no more than 1/8 inch from end.
d. Align weld seams and use a slight twisting motion to FULLY insert male end into female end of joint. Ensure bead in
male end rest against the end of the female pipe.
e.
Smooth sealant around joint for a continuous seal. Reapply sealant if necessary.
f. Slip the locking band over joint and align closest bead in locking band with bead in male end of pipe.
g. Tighten locking band by HAND with a 5/16” nut driver until snug plus ¼ turn. DO NOT SECURE JOINTS WITH
SHEET METAL SCREWS OR POP RIVETS. DO NOT PUNCTURE THE VENT SYSTEM!
h. Oncetheinstallationiscomplete,operateapplianceandinspectalljointstoensurethatuegasesand/orliquid
condensate will not escape.
D. Install Vent Pipe, Burnham Gasketed Vent System.
1. Procedure for Joining Burnham Gasketed Vent Pipe and Fittings. See Figure 3B.
a. Wipe the male end of each joint using an alcohol pad to remove any dirt and grease.
b. Align weld seams in pipes and use a slight twisting motion to FULLY insert male end into female end of joint. Ensure
bead in male end of pipe is below locking band and rest against the end of the female pipe. Verify the factory-installed
gasket is not dislodged or cut.