Note that if the unit is switched off, It will not write to the log and it will not
create a new log file for the number of days it is off, so the older log files in this
case will correspond to previous logs (written several days ago).
Another way of accessing the logs, which may be useful in some cases where the
log file contents need to be copied, is by browsing to a specific URL:
http://IPAddress/LX.log
For example, for today’s log: http://192.168.5.32/TLX.log
Yesterday’s log:http://192.168.5.32/TX-V2.log.1
Previous logs: http://192.168.5.32/TX-V2.log.x
Reboot:
This will reboot the unit.
Update Firmware:
This option allows you to upgrade the firmware of the unit. Click on ‘Choose File’
and select the desired upgrade.dat file. Then click update and wait while the
unit receives the new SW and upgrades the system. The webpage will refresh in 5
minutes. The upgrading process may be finished in two minutes so try refreshing
the page after this time.
Software upgrade files can be downloaded from http://www.bwbroadcast.com
Factory Reset:
This option resets the unit, bringing all parameters to their default value. Network
settings are not affected.
Disconnect:
Clicking this button closes the active web remote session.
Transmitter Controls:
All the controls in the transmitter can be found in this section. These are the
same options that can be found in the front panel control system on the
transmitter itself. Click on the help icon (?) located on the top left of the
screen or refer to the relevant sections of this manual to understand any
particular feature.
TX Model and Serial Number:
The transmitter and product serial number are displayed on the top right of the
page.
To Next Page
Loading...
