BWT AQA Perla User Manual

99
99
9
99
99
9
GBGB
GBGB
GB
1111
1111
11
1212
1212
12
Attach the rinsing water hose (
1111
1111
11) firmly to the Y
piece.
Lead the rinse water hose (
1111
1111
11) with the gradient
to the drain and secure the end against “pressure
wobble” with the enclosed fastening material.
Attach overflow hose (18 x 24) to the safety overflow
(
1212
1212
12), secure with cable connector and lead with a
gradient of at least 10 cm to the drain.
The two hoses leading to the drain must neither
be connected nor show any cross-section
constrictions.
Please note: According to EN 1717 the rinse-Please note: According to EN 1717 the rinse-
Please note: According to EN 1717 the rinse-Please note: According to EN 1717 the rinse-
Please note: According to EN 1717 the rinse-
water and overflow hoses must be attachedwater and overflow hoses must be attached
water and overflow hoses must be attachedwater and overflow hoses must be attached
water and overflow hoses must be attached
with at least a 20mm clearance of the highestwith at least a 20mm clearance of the highest
with at least a 20mm clearance of the highestwith at least a 20mm clearance of the highest
with at least a 20mm clearance of the highest
possible waste-water level at the drain (freepossible waste-water level at the drain (free
possible waste-water level at the drain (freepossible waste-water level at the drain (free
possible waste-water level at the drain (free
outflow).outflow).
outflow).outflow).
outflow).
> 20 mm > 20 mm
> 20 mm > 20 mm
> 20 mm

BWT AQA Perla Specifications

General

Brand	BWT
Model	AQA Perla
Category	Water Dispenser
Language	English