1616
1616
16
GBGB
GBGB
GB
ChecklistChecklist
ChecklistChecklist
Checklist
for proper installation by a professional installer
Has all packaging material been removed
from the brine cabinet?
Is a protective filter connected in series to
the unit in the immediate vicinity?
Is the unit permanently supplied with
electricity and water (mains system pressure
of at least 2 bar)?
Have you opened the Multiblock as far as it
will go?
Have the connecting hoses been properly
connected? (Note flow-direction arrows,
drinking water inlet at the unit’s return flow
inhibitor.)
Has the unit filled itself with water?
Have the rinsing water hose and the safety
overflow been laid to the drain separately
and connected in keeping with DIN
standards? (see Installation)
Have you entered the drinking water
hardness and correctly set the blended
water hardness at the blending valve? (see
Commissioning)
Is the unit metering the blended water
supply? (Open tapping point after the unit and
observe metering of the blended water unit
on the display)
Have you completed the unit log on the back
of these instructions?
Have you drawn the operator’s attention to
the necessary inspection in accordance with
DIN 1988? (check salt supply and blended
water hardness at least every two months)
Have you drawn the operator’s attention to
the necessary maintenance in accordance
with DIN 1988?
(Work according to manufacturer’s specifi-
cations at intervals stipulated by DIN 1988:
once a year, twice a year in the case of
communal units)
After installation andAfter installation and
After installation andAfter installation and
After installation and
commissioning youcommissioning you
commissioning youcommissioning you
commissioning you
can use this list tocan use this list to
can use this list tocan use this list to
can use this list to
check your operationscheck your operations
check your operationscheck your operations
check your operations
once again.once again.
once again.once again.
once again.
To Next Page
Loading...
Need help?
General
