EasyManua.ls Logo

BYD e2 - Page 46

BYD e2
220 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Dashboard
2-1 Dashboard
45
While the motor is running, this warning lamp turns on constantly if the brake fluid
level is normal and the electronic parking system works normally (The electronic
parking switch is pulled up and released normally and no “Please check electronic
parking system.” is displayed).
Both parking system malfunction indicator lamp and ABS malfunction indicator
lamp turn on.
Tip
A short flashing of the warning indicator during operation does not indicate a fault.
Seatbelt not-fastening indicator
This indicator lamp is functioned to remind the driver/passenger of fastening the seat
belt. With power switch at “OK”, if the driver seat belt is not fastened, the seat belt
reminder indicator lamp turns on. This indicator lamp keeps on until the seat belt is
fastened.
Low-voltage power supply system warning lamp
The indicator is used to indicate a charge system fault during the charge process.
The indicator is used to indicate a discharge system fault during the discharge
process.
The indicator is used to indicate the operating status of DC module and battery module
when the charge or discharge operation is not performed.
If this lamp turns on during traveling, it indicates that the DC system or battery system
is malfunctioned. In such case, please turn off A/C, fan, and radio. It’s recommended
to drive the vehicle to the nearest BYD Auto Authorized Service Station for repairs.
SRS fault warning indicator
This warning lamp turns on when the power switch is at “OK” and turns off in several
seconds if the airbag system works normally. This warning lamp is functioned to
monitor the airbag ECU, impact sensor, inflator, warning lamp, wiring, and power
supply.
In any of the following cases, it indicates that a component monitored with the warning
indicator system is faulty, it is recommended to contact BYD Auto Authorized Service
Station for inspection as soon as possible.
When the power supply is in “OK” position, the warning indicator will not be turned
on or be always on.
The warning indicator is turned on or flashes during driving process.

Table of Contents

Related product manuals