BYK-Gardner GmbH Introduction | 1
301 200 141 E 2401 wave-scan 3 ROBOTIC 7
Only devices that meet the requirements for low-voltage safety may be connected
to the control interface (green).
For operation with the external power supply, care should be taken to ensure the
nominal voltage of the power supply unit (see the manufacturer’s plate on the
power supply unit) matches the voltage supplied by the power outlet.
The measurement device may be disconnected from the power supply as follows:
• By disconnecting the power plug (black) from the device.
You will find the technical data on the manufacturer’s plate and in the section
“Technical Data”.
Defects and extraordinary loads
If safe operation can no longer be presumed, shut down the device and secure it
against unintended operation.
The device must be presumed unsafe to operate:
• if visible damage is evident,
• if the instrument is no longer working,
• if it has been stored for long periods under adverse conditions,
• after harsh treatment during shipping.
Additional information on disposal
This symbol means: Do not dispose of this product together with your household
waste. Please refer to the information of your local community or contact our deal-
ers regarding the proper handling of end-of life electric and electronic equipment.
Recycling of this product will help to conserve natural resources and prevent po-
tential negative consequences for the environment and human health caused by
inappropriate waste handling.
To Next Page
Loading...
Need help?
General
