BYK wave-scan 3 - Getting Started with wave-scan 3; Initial Setup and System Diagram

To Next Page

To Previous Page

3 | Cabling BYK-Gardner GmbH

18 wave-scan 3 ROBOTIC 301 200 141 E 2401

3.4 USB Cable

For initialization the instrument provides an additional USB port.

1 2

Illustration13: Interfaces on wave-scan 3 ROBOTIC

1 Power interface (black)

2 Data interface (green)

3 USB type C interface

Perform following steps:

1. Connect the instrument via the USB cable in the delivery with your PC.

2. Provide power to the instrument via power cables and black interface.

3. Start software smart-robotic for initialization and configuration.

Details for instrument initialization see Device Configuration [}20]. After initial-

ization and configuration the USB cable can be disconnected. In the productive en-

vironment the green data interface is used for communication.

Other manuals for BYK wave-scan 3