BYK wave-scan 3 User Manual

3 | Getting Started BYK-Gardner GmbH
20 wave-scan 3 / wave-scan 3 dual 301 200 085 E 2403
3.2.2 Charging the Instrument
The charging takes place via the docking station:
1. Connect the docking station to the power supply.
2. Remove the protection plate from the instrument.
3. Put the instrument into the docking station.
Both battery packs are charged. The battery pack in the docking station is charged faster than
the one in the device.
Three charge LED indicate the current state:
• Left: Docking station is powered.
• Middle: Battery pack #1 in the instrument is charged.
• Right: Battery pack #2 in the docking station is charged.
For the charge LED following rules apply:
• LED pulsates red as long as the battery charge is < 15%.
• LED pulsates yellow as long as the battery charge is < 50%.
• LED pulsates green as long as the battery charge is < 90%.
• LED lights up in green when the battery charge is ≥ 90%.
With green LED light the device is fully charged and can be put in operation. Keep the device in
the docking station if it is not in use.

BYK wave-scan 3 Specifications

General

Brand	BYK
Model	wave-scan 3
Category	Measuring Instruments
Language	English