BYK-Gardner GmbH Standard Measurements | 5
301 200 085 E 2403 wave-scan 3 / wave-scan 3 dual 35
5.5.3 Final Menu
After a successful measurement the menu contains following options.
The available options are:
• Sample > Edit: See above.
• Test series > Edit: See above.
• Delete last measurement: Enables you to repeat the last measurement.
• Delete sample: Enables you to repeat all measurements on the current sample.
• Delete test series: Enables you to repeat the complete test series.
• End test series: Enables you to stop the current test series. You can continue later.
• Interrupt statistics: Interrupts the measurements on the current sample before reaching
the preset number of measurements, details see Statistics [}48].
Perform the next measurement and all other required measurements on the first sample.
5.5.4 Next Measurement
When all measurements according to the current statistics settings are done, the next measure-
ment will be automatically assigned to the next sample.
Proceed with the following steps:
• Perform the next measurement until the current sample is completed.
• Measure the next sample until the current test series is completed.
• Repeat this procedure for all other test series until the current standard is completed.
To Next Page
Loading...
