To Next Page

To Previous Page

8 | Configuration BYK-Gardner GmbH

48 wave-scan 3 / wave-scan 3 dual 301 200 085 E 2403

8.1.1 Scales

Via this function you can decide, which data is to be displayed in the measurements results.

Following entries are default scales:

• Dullnes (du)

• Wavelength - Range A (Wa)

• Wavelength - Range B (Wb)

• Wavelength - Range C (Wc)

• Wavelength - Range D (Wd)

• Wavelength - Range E (We)

• Longwave (LW)

• Shortwave (SW)

• Structure Balance (B)

All other scales are project-specific. Consult your project documentation for more information.

NOTICE

Measurement data will be saved for all scales. The activation of a scale has no impact on the

data to be saved; it just toggles the display of a scale while measuring.

8.1.2 Statistics

If the number of measurements is set to a value greater than 1, statistics values are shown in

the display after measurement.

Other manuals for BYK wave-scan 3

Questions and Answers:

Need help?

Do you have a question about the BYK wave-scan 3 and is the answer not in the manual?

General