To Next Page

To Previous Page

8 | Configuration BYK-Gardner GmbH

56 wave-scan 3 / wave-scan 3 dual 301 200 085 E 2403

If the differences are within your tolerances, you can continue to measure with your instrument.

Otherwise clean the standards and repeat, see Cleaning Instructions [}60].

NOTICE

All measurements on the checking tiles are stored in the instrument. Transfer the measurement

data to “smart-chart” to document all test case performed.

8.6 Factory Reset

If you are having technical problems with your instrument, you can perform a fallback to the

factory settings.

Confirm the security message to perform the fallback. You must enter the password “byk-in-

struments”, see also Technical Data [}68] > section General Data.

After fallback all your personal configuration and measurement data in the device will be lost.

The instrument starts in a fresh state.

Other manuals for BYK wave-scan 3

Questions and Answers:

Need help?

Do you have a question about the BYK wave-scan 3 and is the answer not in the manual?

General