3-6 FlexNet
®
700 Series Line Extender Rev F
3
Strand/Pedestal Mounting With Extension Mounting Brackets (EMBs)
Use Extension Mounting Brackets to mount the E7 Line Extender if additional space is required
between the unit and the strand. The following kits are available:
■ 3.2-inch (8cm) EMB (P/N 172187-01)
■ 6-inch (15cm) EMB (P/N 172187-03)
Strand diameter determines the orientation of the strand clamp. Refer to Figure 3.5 on page 3-7.
➤ To strand or pedestal mount with EMBs
1. Attach the EMBs to the top strand clamp bosses with the 1/2-inch long EMB bolts and lock
washers provided with the EMB assembly, as shown in Figure 3.5. Finger tighten the bolts
against the EMBs.
2. Attach the strand clamp assemblies to the EMBs with the 1-inch long clamp bolts and washers
(see Figure 3.5).
3. Hoist the housing to the strand and hang it in position.
4. Tighten the clamp bolts enough that the housing cannot come off of the strand, but is still free
for adjustment.
5. Position the housing at a location on the strand that is accessible for attaching cables and
performing maintenance and balancing, and that complies with the requirements of the
system.
6. Torque both the clamp and EMB bolts to between 40 and 66 in-lbs (4.5 to 7.5N·m).
Note: Extension Mounting Brackets (EMBs) are not included with the unit but may be
purchased separately. Contact C-COR for ordering information. Each EMB kit includes
the following additional mounting hardware:
■ 1/4-20UNC x1/2-inch bolt
■ 1/4-inch lock washer
■ 1/4-20UNC nut
To Next Page
Loading...