C-more micro EA1-S6ML - Rear View; Enclosure Clearances

EA1-MG6-USER-M Hardware User Manual, 1st Ed. Rev C, 09/10
1–10
Chapter 1: Getting Started
1
®
Enclosure Clearances
A 1.2” [30mm] minimum clearance is required inside an enclosure for proper ventilation of
the C-more Micro-Graphic panel.
1.2
[30.0]
1.2
[30.0]
Enclosure Enclosure
8 1
15
9
I T D
I T D
M 7
M 7
D te o e * **
D te o e * **
R01
R01
MAD IN HI A
MAD IN HI A
E 1 S6M W + se a num er
E 1 S6M W + se a num er
MODE : A1 S6M
MODE : A1 S6M W
N UT 12- 4V 6 5W
N UT 12- 4V 6 5W
ND C NT Q.
ND C NT Q.
1.2
[30.0]
1.2
[30.0]
1.2
[30.0]
1.2
[30.0]
Enclosure
units: inches [mm]
EA1-S6ML(W) with
EA-MG6-BZ2(P)
EA1-S6ML(W)
NOTE: Additional clearance inside the enclosure is required when connecting to the 15-pin serial
communications port (Port2).
EA1-S6ML(W)
Rear View
Panel with Keypad
Bezel
Panel only