CAB SQUIX Series User Manual

48 48
9 Extras
9.1 Firmware Update
i
Notice!
The rmware le can be obtained from the internet.

Access only with external storage device!
 Copythermwareletothe"misc"directoryofthestoragedevice.ThiscanbedoneonacomputerorviaFTPon
the printer.
 Insert the prepared storage device into the printer.
 Start menu.
 Select Extras.
IfthemenuisprotectedviaaPINapromptappearsinthedisplay.Enterthecodenumberandconrmit.
 Select Firmware update.
Thedisplayshowstheselectionofexternalstoragedevicesandthermwarelesstoredonthedevices.
 Selectaleandconrmwith .
Theselectedrmwareleiscopied.Aprogressindicatorisdisplayedwhilethermwareisbeingcopied.After
completion the printer will be re-started.

i
Notice!
The rmware update also can be done via FTP printer management  "12.4" on page 55.
9.2 Save Settings
With the Save settingsfunctiontheprintercongurationcanbesavedtoastoragedevice.
 Start menu.
 Select Extras.
IfthemenuisprotectedviaaPINapromptappearsinthedisplay.Enterthecodenumberandconrmit.
 Select Save settings.
 Select the external storage device.
 Enteralename.
Thepredenednameiscomposedoftheidentier"gui",date,clocktimeandthesufx".xml",butmayalsobe
altered.
 Conrmtheselectionwith .The.xmllewillbestoredinthefolder/miscofthestoragedevice.
An error message appearing during the saving procedure may be caused by an unreadable medium (e.g. unknown
medium, unformatted medium)  "13.5.4" on page 58.
9.3 Load Settings
AprintercongurationpreviouslysavedtoastoragedevicecanbeloadedwiththeLoad settings function.
 Start menu.
 Select Extras.
IfthemenuisprotectedviaaPINapromptappearsinthedisplay.Enterthecodenumberandconrmit.
 Select Load settings.
 Selectthedesiredle.
 Conrmtheselectionwith .Loadingofthecongurationdatastarts.DonotremovetheUSBashdrive
until the loading procedure is complete. The printer returns to the Extras menu.
If an error occurs during the loading procedure, an error message appears in the display. Restart the loading
procedureinthiscase.Ifanerroroccursagain,thecongurationparametersmustbeenteredviathecontrolpanel.

CAB SQUIX Series Specifications

General

Peeler	Optional
Print Technology	Thermal transfer
Connectivity	USB, Ethernet
Display	LCD
Sensors	Label gap sensor
Print Resolution	300 dpi