Windshield Wipers
WIPER:
Turn the band
on
the turn signal lever to
control the wipers.
MISE
Turn
the band toward you and then release it for
a single wipe cycle, For more cycles, hold the band on
MIST longer.
LO
or
HI:
Turn the band away from you to either
LO
(low speed) or to
HI
(high speed), depending
on
the
wiper speed you want.
DELAY:
You
can set the wiper speed
for
a long
or
short
delay between wipes with this setting. Move the band to
the
DELAY
position. The closer you move it to
LO,
the
longer the delay. (Eldorado Only)
OFF:
Turn the band to
OFF
to
turn
off
the wipers.
Be
sure
to
clear ice and snow from the wiper blades
before using them.
If
they're frozen
to
the windshield,
carefully loosen or thaw them.
If
the blades do become
damaged, get new blades or blade inserts.
Heavy snow or
ice
can overload the wiper motor.
A
circuit breaker will stop the motor until
it
cools. Clear
away snow or ice to prevent an overload.
Rainsense Wipers
(ETC
Only)
This moisture sensor is mounted on the passenger's
interior side of the windshield behind the rearview
mirror and
is
used to automatically operate the wipers
by monitoring the amount
of
moisture that
is
on
the windshield.
2-34
To Next Page
Loading...
