Training
a
Garage
Door
Opener with
“Rolling Codes”
(If
Equipped)
If
you
have not previously programmed the hand-held
transmitter to
the
universal transmitter. see
“Programming the Transmitter” earlier in this section. If
you have completed this programming already. you now
need to train the garage door opener receiver
to
recognize the universal transmitter. Refer to your garage
door opener owner’s manual
for
the proper transmitter
training procedure for your garage door opener brand.
1.
2.
3.
Locate the training button
on
the garage door opener
receiver. The exact location and color
of
the button
may vary by garage door opener brand.
If
you have
difficulty locating the training button. refer to your
garage door opener manual.
Press the training button on the garage door opener
receiver for one or two seconds.
A
light indicator
will begin
to
flash when the receiver enters the
train mode.
Return to
the
universal transmitter
in
your vehicle
and press the universal transmitter button
you
have
already programmed for two to three seconds. Press
the
button again to make sure that
the
universal
transmitter has been trained to the garage door
opener receiver. Check that the training was
successful. The receiver light should
no
longer
be flashing.
The garage door opener should now recognize the
universal transmitter. You may either use
the
universal
transmitter or the hand-held transmitter to open the
garage door.
If
after following these instructions you still have
problems training the garage door opener, consult
your dealer.
Erasing Channels
To
erase all three-programmed channels, hold down
the two outside buttons until the red light begins to
flash. Individual channels cannot be erased, but can be
reprogrammed using the procedure for Programming
the
transmitter explained earlier.
Accessories
Accessories for the universal transmitter are available
from
the
manufacturer of the unit.
If
you would like
additional information, please call
1-800-355-35
15.
2-55
To Next Page
Loading...
