Power
Lumbar
Control
(If
Equipped)
The
lumbar control is
located
on
the outboard side
I I
of
each front seat.
It
provides additional support
to your lower back and it
works independently
of
the
other seat controls. Use the
power seat control first
to
get the proper position.
Then proceed with the
lumbar adjustment.
To
reshape the lower seatback, press the lumbar control
forward to increase support and rearward to decrease
support. Press the control up or down
to
raise or lower
the support mechanism.
Keep in mind that as your seating position changes,
as
it
may during long trips,
so
should the
position
of
your
lumbar support. Adjust
the
seat as needed.
If
you have the optional personalization package, the
power lumbar control can be programmed for memory
recall. For more information. see “Programmable,
Memory and Personalization Features”
in
the Index.
Memory
Seat
and
Mirrors
(If
Equipped)
Automatic
seat
and mirror movement will occur if the
Remote Keyless Entry
(RKE)
transmitter is used to
enter the vehicle. The number
on
the back
of
the
transmitter corresponds to the
1
or
2
seat and mirror
position. After the unlock button is pressed on the
RKE
transmitter (the ignition must
be
in
LOCK)
or when the
key is placed in the ignition, the seat and mirrors will
automatically adjust
to
the appropriate position.
Automatic seat and mirror movement
is
programmed
through the Driver Information Center
(DIC)
so
that the
driver can select whether or not movement will occur
using the
RKE
transmitter or by placing the ignition
key
in
the
ignition. For programming information, see
“Pragrammable, Memory and Personalization Features”
in
the Index.
1-3
To Next Page
Loading...
