EXT
LIGHTS
AT
UNLOCK:
Exterior lamps (parking
lamps, taillamps, sidemarker lamps, license plate lamps,
low-beam headlamps, etc.) turn
on
when the unlock
button
on
the remote keyless entry transmitter is pressed
and
it
is dark outside. These lamps stay on for about
20
seconds or until the key is turned OFF.
The prompts listed here appear in the same order as
displayed on
the
Driver Information Center (DIC).
FEATURE
ON
appears when a yes response is made
and FEATURE OFF appears with a no response. To
skip
to
the next personalization feature (REMOTE
RECALL MEMORY), press the
INFO
button.
Remote
Recall
Memory
(If
Equipped with
Memory Personalization)
Memory settings that have been previously programmed
(climate control settings,
radio
preset settings, exterior
lighting choices, remote confirmation choices and
programmable automatic door lock choices) can be
recalled by using the remote keyless entry transmitter or
by placing the key in your vehicle’s ignition.
Before
you
begin programming, make sure that your
vehicle’s ignition
is
in RUN.
To
begin programming,
press the
INFO
and
INFO
RESET
buttons at the same
time for about two seconds. As mentioned, remote recall
memory
is
the third feature
to
appear.
To
skip past the
first two personalization features, press the
INFO
button.
When REMOTE RECALL MEMORY appears, the
driver is able to recall memory settings when the unlock
button on the remote keyless entry transmitter is
pressed. Press
the
TRIP RESET button to select
or
press
the
INFO
RESET button to answer no and to continue
on
to the next prompt. FEATURE
ON
displays when a
yes response
is
made.
If
a
no response was made, the
KEY
IN
RECALL
MEMORY prompt will’ show next.
This
choice recalls
memory settings when the key is placed
in
your
vehicle’s ignition. FEATURE
ON
displays for a yes
response, and FEATURE
OFF
for a no response. A yes
or
no
response
is
required.
2-82
To Next Page
Loading...
