FF:
Press the right arrow
to
fast forward to another part
of
the tape. The radio will play while the tape advances.
You may use your station pushbuttons
to
tune to another
radio station while in
FF
mode. Press the right arrow
again to return
to
playing speed.
TUNE-SEEK:
When this button is pressed, it has two
positions. This button works the same, whether
it
is
pressed to the first or second position. Press this button
to seek to the next or previous selection on the tape.
Your tape must have at least three seconds of silence
between each selection
for
TUNE-SEEK to work. The
sound will mute while seeking.
SCAN:
Press this button to listen to selections for a few
seconds. The tape will go to a selection, stop for a
few
seconds, then
go
on
to
the next selection. Press this
button again
to
stop
scanning.
SIDE:
Press this button
to
change the side
of
the tape
that is playing.
A
EJECT
Press
the
upward triangle button to
remove a tape. The radio will play. Eject may be
activated with the radio
off
andor the vehicle
ignition off.
CLEAN TAPE:
If this message appears on the display,
the cassette tape player needs to be cleaned. It will still
play tapes, but
you
should clean it
as
soon as possible to
prevent damage to the tapes and player. See “Care
of
Your Cassette Tape Player’’ in the Index. After you clean
the player, press and hold
EJECT
for three seconds to
reset the CLEAN
TAPE
indicator.
Dolby Noise Reduction is manufactured under a license
from Dolby Laboratories Licensing Corporation. Dolby
and the double-D symbol are trademarks
of
Dolby
Laboratories Licensing Corporation.
Auto Cr02 allows the cassette tape player to adjust to
the type of cassette tape for clearer sound for Cr02
cassette tapes.
3-16
To Next Page
Loading...
