PUSHBUTTONS:
The
six
numbered pushbuttons let
you
return to your favorite stations. The
RDS
PTY
mode
must be
off
to use this mode. You can set up to
24
stations
(six
AM,
six FM1, six
FM2
and six weather). Just:
1.
Turn
the radio on.
2.
Press BAND to select AM, FM
1,
FM2 or weather.
3.
Tune
in
the desired station.
4.
Press and hold one
of
the
six
numbered buttons for
more than two seconds. Whenever you press that
numbered button
for
less than two seconds, the
station
you
set will return.
5.
Repeat the steps for each pushbutton.
When battery power is removed and later applied,
you
will
not
have to reset your radio presets because the
radio remembers them.
PRESET
SCAN:
Press and hold SCAN for more than
two seconds until you hear a beep to listen to each of
your preset stations for five seconds. The radio will
go
to
the first preset station stored on your pushbuttons,
stop for five seconds,
then
go
on
to the next preset
station. Press SCAN again
to
stop scanning. If a preset
station has weak reception, the radio will not stop at the
preset station.
Using
RDS
Mode
Your audio system
is
equipped with Radio Data Systems
(RDS). RDS mode gives you many useful new features.
When
RDS
is on, the radio can:
seek only to stations
with
the types
of
programs you
want
to
listen
to.
seek to stations with traffic announcements.
0
receive announcements concerning local and
national emergencies,
0
receive and display messages from radio stations and
0
search for a stronger station when a station is too
weak for listening.
RDS
features are only available for use
on
FM
stations
which broadcast
RDS
information.
0
RDS
SELECT
Press
the
orange rectangular
button to use the alternate RDS functions (RDS,
TA,
MSG,
PTY and
<
PTY
>
)
located on the
six
numbered
pushbuttons.
RDS
SELECT:
will appear on
the
display.
The alternate
RDS
functions are only available
when
you
are using the
FM
band of your radio.
3-19
To Next Page
Loading...
