If
a station with the selected PTY is not found,
NONE
FOUND will appear on the display. If both PTY and TA
are
on,
the radio will search for stations with traffic
announcements and the selected PTY.
PUSHBUTTONS:
The
six
numbered pushbuttons let
you return to your favorite Program Types (PTYs).
These buttons have factory PTY presets. See “Radio
Data Systems (RDS) Program Type (PTY) Selections”
in the Index.
You
can set up
to
12
PTYs (six
FMl
and
six FM2). Just:
1,
Turn PTY
on.
2.
Press BAND to select
EM1
or FM2.
3.
Tune an
RDS
station with the PTY you desire.
4.
Press and hold one of the six numbered buttons for
more than two seconds until
you
hear a beep.
Whenever
you
press that numbered button for less
than two seconds, the PTY you
set
will return.
5.
Repeat the steps for each pushbutton.
When battery power is removed and later applied,
you
will
not
have
to
reset your RDS presets because
the
radio remembers them.
HR
or
MN:
Press
the
RDS SELECT button, followed
by
one
of
these buttons
to
display the time
for
the
current station. STATION TIME IS will be displayed. If
a time has not been
sent
to
the
radio,
NO
STATION
TIME will be displayed. If
you
have recently tuned to
the station, you may need
to
wait a minute before
the
time is available to the radio. To set the clock
to
the
current displayed station time, press and hold HR or
MN
until TIME UPDATED is displayed. There
is
a two
second delay before the time is updated. RDS mode
does
not
have to be
on
to use this function. but
you
must
be tuned to an
FM
RDS
station.
ALERT
This type of announcement warns of national
or local emergencies. You will not be able
to
turn
off
alert announcements. Alert announcements will come on
even if RDS mode is turned off. ALERT appears
on
the
display when an alert announcement plays. The radio
uses
TA
volume during these announcements. To
increase volume,
turn
the
PWRNOL
knob
to
the right.
Turn
it to the
left
to
decrease volume.
TA VOLUME
will appear
on
the
display while the volume is being
adjusted. When an alert announcement comes
on
the
tuned radio station or a related network station, you will
hear it, even if the volume
is
muted or
a
cassette tape or
compact disc is playing. If the radio tunes to
a
related
network station
for
an alert announcement,
it
will return
to the original station when the announcement is
finished. If the cassette tape or compact disc player, play
will stop for the announcement and resume when the
announcement is finished.
To Next Page
Loading...
