4.
With the coolant surge tank pressure cap off. start the
engine and
let
it
run
until
you
can feel the upper
radiator hose getting
hot.
Watch out for the engine
cooling fans.
By this time, the coolant level inside the coolant
surge tank may be lower. If the level
is
lower, add
more
of
the proper mixture to the coolant surge tank
until
the level reaches about
2.5
inches
(6.4
cm)
below the base of the filler neck.
a
5.
Then replace the pressure cap. Be sure the
arrows
on
the pressure cap
line
up like
this.
Start the engine and allow it to warm up. If
the
CHECK
COOLANT
LEVEL
message does
not
appear on the
Driver Information Center, coolant
is
at the proper fill
level.
If
a
CHECK
COOLANT
LEVEL
message does
appear, repeat Steps
1
through
3
or see your dealer.
5-23
To Next Page
Loading...
