#9 Viper_SC_Manual_001-5008-000_Rev12e.docx | Page 91
5.2.3 INCREASE OIP AND MAC RETRIES LIMIT
OIP retries and MAC retries are only available in Router mode. The MAC Retry Limit is normally set to 1 and the OIP Retry
Limit is normally set to 2. Gradually increasing these limits (up to 3 in extreme cases), may provide a slower, but more
reliable link impossible with weak signals. Use in conjunction with the slower over-the-air network bit rate for the system’s
bandwidth.
The number of MAC retries can be configured on the Viper’s web pages under Setup (Advanced) RF Optimizations. The
number of OIP retries can be configured under Setup (Advanced) IP Optimization.
To Next Page
Loading...