EasyManuals Logo

CalAmp Viper 100 User Manual

CalAmp Viper 100
115 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #101 background imageLoading...
Page #101 background image
#9 Viper_SC_Manual_001-5008-000_Rev12e.docx | Page 94
200-Firmware Version: . FIRM-03_10-R
200-ASD Data Map: . . . 2.0
200-Radio Circuit Board: 0.10
200-Radio Serial Number: 405163
200 Radio Model Number: 823-5028-452
Check that the “Firmware Version:” shows the latest firmware revision.
Figure 72 Using Windows Command Prompt to upgrade Radio Firmware
5. Restart the Viper SC. You can restart the Viper SC by typing “stationreset” in the CLI then pressing enter.
6.3 VERIFY FILE INTEGRITY
1. Using your browser, connect to the unit’s IP address.
2. Enter the user name and password. Allow the Welcome page to load.
3. In the left pane, select UNIT STATUS. The Unit Identification and Status pane should display the newly upgraded
firmware in its Banner and the H/W Status should also show Ok.
4.
If the message in the result screen points out that file(s) failed the integrity check, retry the FTP transfer for the failed
files(s) again. If the problem persists, please HAVE THE PACKAGE CONTROL RESULTS READY AND CONTACT CALAMP
TECHNICAL SERVICES.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CalAmp Viper 100 and is the answer not in the manual?

CalAmp Viper 100 Specifications

General IconGeneral
BrandCalAmp
ModelViper 100
CategoryNetwork Router
LanguageEnglish

Related product manuals