#9 Viper_SC_Manual_001-5008-000_Rev12e.docx | Page 83
Blocks Total
The WCP server sends the filename in small blocks. This number represents the number of blocks the server divided
the file into.
Block Written
Number of blocks that have been successfully written into the Viper non-volatile memory
Completed (%)
Completion ratio (blocks written over total number of blocks)
Cmd
The last WCP command received by the client
Contact your authorized CalAmp representative for availability and details on the Wing Commander Server.
4.7.7 FEATURE OPTIONS
The Feature Option page shows the available features and shows which features are currently installed in the Viper SC.
Table 12 – Available Feature Options
4.8 NETWORK MANAGEMENT/NEIGHBOR TABLE
Each unit is equipped with a powerful neighbor discovery module. The purpose is to detect all units in the RF network and
add all necessary IP routes required to reach neighboring units. Vipers discover other Viper by sending and receiving
neighbor discovery control messages.
From the navigation frame, select Network Management to access Viper Neighbor Management options. This page also
displays information about local status, discovered neighbors, and control operations.
There are three modes of operations (Manual-Scan, Auto-Scan, Disabled); five states of operations (Ready, Scanning for
Neighbors, Disabled, Saving Neighbor Table, Testing Connectivity); and three types of Neighbor Table entries (Static,
Dynamic, Locked).
Neighbor discovery is only operational in router mode.
Allows SNMP agent activation on the unit.
To Next Page
Loading...
Need help?
General
