Need help?Do you have a question about the Calculated Industries HeavyCalc and is the answer not in the manual?
General| Brand | Calculated Industries |
|---|---|
| Model | HeavyCalc |
| Category | Calculator |
| Language | English |
Highlights the calculator's primary functions including dimensional math, conversions, area, volume, and estimation.
Defines fundamental calculator keys like math operators, percent, digits, Power Off, and On/Clear.
Explains keys for storing constants, memory add/subtract, and recall/clear operations.
Details entry for Yards, Feet (including Feet-Inch), Inches, Meters, Millimeters, and fraction handling.
Defines keys for area, volume, square-up, percent grade, slope, and cut/fill calculations.
Covers reciprocal, all clear, Pi, +/- toggle, tape access, per-unit cost, and fractional rounding settings.
Guides on entering linear, square, and cubic dimensions and performing basic calculations.
Demonstrates conversions between various linear, square, and cubic units.
Explains chaining logic, dimensional math, and percentage calculations.
Details memory functions, averaging, and using the paperless tape for reviewing calculations.
Shows how to calculate areas of rectangles and volumes for concrete, topsoil, and trenches.
Explains solving for square-up, slope, grade, lot width, and drop/fall scenarios.
Covers cut/fill calculations, grid cell volumes, and shrink/swell material volume conversions.
Explains display accuracy, error handling, auto-range, battery, auto shut-off, and reset functions.
Details warranty, repair services, FCC compliance, and product disclaimers.
To Next Page