Calculated Industries HeavyCalc - Page 7

[ / ]
Fraction Bar — This key is used to
enter fractions. Fractions can be
entered as proper (1 or less – 1/2, 1/8,
1/16) or improper (greater than 1 –
3/2, 65/64). For example, to enter 1/2,
the key sequence would be: 1 [ / ] 2.
If the denominator (the bottom num-
ber) is not entered, then the set frac-
tional level (1/16, 1/2, etc.) is used.
[Rcl] [/] displays the current fractional
setting.
[Rcl] [x]
Imperial/Metric Mode — S e l e c t s
either Imperial or Metric defaults for
the following settings: pitch, stair riser
height, and on-center spacing.
[Cu]
Cubic — This key is used with a
dimension key (feet, inches, yards,
meters, or millimeters) to identify a
volume value. Example: 5 [Cu] [Yds].
[Sq]
Square — This key is used with a
dimension key (feet, inches, yards,
meters, or millimeters) to identify an
area value. Example: 10 [Sq] [Feet].
User’s Guide – 7