Cambridge Audio One+ - Setting Radio Presets; Audio Adjustments; Setting the Clock

19
Treble
1. Press the Menu button on the remote or front panel until "Treble" is displayed. To
adjust use the Volume control on the remote or rotate the Volume dial.
2. Press the Enter button or Volume/Select to accept and exit.
X- Bass
The X-Bass function has been developed to make an attempt to compensate for
smaller ‘bookshelf’ or ‘satellite’ speakers that may lack low bass output.
When X-Bass is On an extra boost of approx 8dB centred around 85Hz is applied to
compensate for the natural roll-off of small speakers.
For larger hi-fi speakers X-Bass should be Off.
1. Press the Menu button on the remote or front panel until "X-Bass" is displayed. Use
the Volume control on the remote or rotate the Volume dial to turn On or Off.
2. Press the Enter button or Volume/Select to accept and exit.
Setting the clock
The user can either allow RDS FM (or DAB) transmissions to automatically set the
clock time/date (sync mode), or the clock can be set manually if you cannot receive
suitable RDS FM or DAB transmissions. To change the clock 'Sync modes':
1. Press and hold button on the remote control until the display reads 'Clk Mode'.
2. Use the   buttons on the remote to scroll between RDS 'Sync' mode and
'Manual' mode.
3. Press button to confirm your choice and exit from clock setting.
If Manual mode is selected, you can set the time by first adjusting the hour using the
  buttons, then press again to adjust the minutes. Press to finish.
Operating instructions (continued)
In FM mode, you can also press the Menu button which will first bring up a <Freq
Select> menu item. This also allows you to scroll to and select any desired station if
you know its frequency using the volume control.
Setting presets in DAB or FM modes
One+ can store up to 10 presets for each of the DAB and FM bands.
1. Select the band and station you wish to store,
2. Press and hold the desired preset number for 4 seconds (e.g 1). The display on the
unit shows that the station has been stored.
3. To store presets 6-10, press the Shift button first, then press and hold the desired
preset number.
4. Briefly press the chosen preset button at any time to recall and listen to
corresponding station.
Adjusting the Balance, Bass, Treble and X-Bass
Note: These adjustments do not affect the signals sent through the Tape output
connections.
Balance
1. Press the Menu button on the remote or front panel until "Balance" is displayed.
Use the Volume control on the remote or rotate the Volume dial to adjust the relative
output levels of the left and right channel.
2. Press the Enter button or Volume/Select to accept and exit.
Bass
1. Press the Menu button on the remote or front panel until "Bass" is displayed. To
adjust use the Volume control on the remote or rotate the Volume dial.
2. Press the Enter button or Volume/Select to accept and exit.