20
ENGLISH
Setting the alarm
The Alarm function will turn on the unit at a chosen time. To set the alarm time:
1. Briefly press on your remote control. 'Alarm: DAB Pr 1' will appear on the front panel
display. Use the buttons to select if you wish the alarm to wake you to DAB
preset 1 or FM preset 1. The Alarm will only wake to either of these two timer presets.
2. Briefly press the again. Use the buttons to select if the alarm should be
off, operate once, or every day.
3. Press to accept and progress to set the hour. Use the buttons to alter the hour.
4. Press to accept and repeat the process to set the minutes.
5. Press to set alarm volume (default volume level 10). Use the buttons to
set the volume level.
6. Press to finish.
Note: Alarm setting can always be checked when the unit is in Standby by pressing the
i button.
Setting the sleep time
The Sleep function will turn off the unit after a selected interval. To set the sleep time:
1. Press Sleep button on the remote. Choose between 15mins, 30mins, 45mins,
60mins, 90mins and Off by pressing Sleep button accordingly to your chosen time.
Off means the sleep timer is disabled.
2. Press Enter button to accept and return to previous state.
Playing CDs
One+ supports standard audio CDs and CD-R/CD-RWs with MP3/WMA music files.
Normal disc play
1. Select CD mode or load the disc into the CD slot. Once the disc is loaded, the source
will automatically switch to CD mode.
2. Press button to begin playback. The disc will start playing from the beginning of the
first track. When the last track has finished playing, the unit will go to Standby mode.
3. To stop the disc at any point, press the button. Pressing the button while the
disc is playing will pause the disc. When the disc is paused the display will flash, play
can be resumed by pressing the button again.
4. To eject disc, press the button.
Note: The unit must be in CD source mode for the disc to eject.
Locating a specific track
1. Ensure that a disc is loaded.
2. Pressing the right button once will forward CD by one track. Repeat as necessary.
3. Press . The disc will play to the end of the disc and then return to 'Standby' mode.
4. Pressing the left button will access the previous track.
Locating a particular point in a track
1. Ensure that the disc is playing the desired track.
2. Press and hold or , the CD will then fast foward or rewind within the track.
Audio is muted during searching.
3. Release the button when the desired time has been reached. Play will resume.
Playing MP3/WMA from USB, SD or CD
Plug the USB device into the USB port, insert the memory card into SD card slot located
on the front panel or insert CD to cd slot, select the desired source using the Source
button. The unit will automatically read the contents before it can be played.
Compatible bitrates
MP3 - 96, 128, 192, 256 and 320 kbps.
WMA - 48, 64, 96, 128, 160 and 192 kbps.
To Next Page
Loading...
