CAME BK Series Installation Manual

iU 2
5
2
U
2
2 C l
p. 23 - Manual FA01292-EN - 12/2018 - © CAME S.p.A. - The contents of this manual may change, at any time, and without notice. - Original instructions
DELETING SINGLE USERS
Select U2. Press ENTER to confirm. ❶
Use the arrow keys select the number of the user you wish to delete. Press ENTER to confirm...❷
The Clr wording will appear to confirm the deletion. ❸
From the docs.came.com portal, download the L20180423 module for registering the users.
ENTERING USERS WITH AN ASSOCIATED COMMAND
Select U1. Press ENTER to confirm. ❶
Select a command to associate to the user: The commands are:
- 1 = step-step (open-close);
- 2 = - sequential (open-stop-close-stop);
- 3 = only open;
- 4 = partial opening/pedestrian.
Press ENTER to confirm... ❷
... a number from 1 to 25 will blink for a few seconds. Send the code from the transmitter or other control device, such as, a keypad selector or a
transponder.❸
Mark the user entered in the table LIST OF REGISTERED USERS.
MANAGING USERS
 When adding and deleting users, the flashing numbers appearing are those numbers that are available and usable to assign to a new user (max.
250 users).
 Before registering the users, make sure the AF radio card is plugged into the connector (see the paragraph called CONTROL DEVICES).

CAME BK Series Specifications

General

Motor Voltage	230 V AC
Operating Temperature	-20°C to +55°C
Power Supply	230V AC
Motor Power	300W
Limit Switch Type	Mechanical
Safety Features	Obstacle detection