CAME ZE5 - End-Stop Programming; Resetting Dip-Switch 8; Programming Notes

ïïïï
ACCES.
LINE
-A.C.T.+
-ENC+
1 2 3 4 5 6 7 8 9 10 11 12
05 06 07 08 09 V1 V2 V3
ZE7
OP./CL.
CONTROL
5A
ïï
C. BOARD
ïï
1,6A
CH1/OP.
CLOSE
BOARD
ïï
630mA
ï ï
V
W
U
E1
E3
1234
ON
5678
910
10 11 12357C1 FA
8 OFF
Pag.
15
15 - Manual code:
319T92
319T92 ver.
2.0
2.0 11/2012 © CAME cancelli automatici s.p.a.
The data and information reported in this installation manual are susceptible to change at any time and without obligation to notify users.
EN
Reset dip-switch 8 to OFF.
Note: if the LED indicator begins to flash rapidly
after resetting dip 8, it is necessary to repeat the
procedure from the beginning.
General notes during programming make sure to have memorised the closing end-stop first, otherwise the data will not remain
memorised.