CAME ZM3E - Programming: System Information and Tests; Run Counts and System Reset; Motor Test and Password Setup

p. 27 - Manual FA01317-EN - 01/2020 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
No. runs
Display the number of completed manoeuvres.
[INFO] [No. runs]
Initial message
Change the initial message.
[INFO] [Initial msg] [WWW.CAME.COM] (Default)
Press ENTER to change the initial message.
Use the ENTER key to move the cursor forwards.
Use the ESC key to move the cursor backwards.
Use the arrows to select a letter or a number.
Press and hold ENTER for a few seconds to confi rm.
Resetting the system
Restore factory settings.
[INFO] [System reset] [Confi rm? (No)]
[Confi rm? (Yes)]
Press ENTER to confi rm.
Motor test
Check the gate leaves open in the right direction.
[MOT TEST] [<=M1 M2=>]
Press and hold the button < button.
Check that M1 performs opening.
Press and hold the button > button.
Check that M2 performs opening.
If the leaf does not move in the correct direction,
invert the motor phases.
Password
Set a 4-digit password to access the main menu.
[Password] [Confi rm? (No)]
[Confi rm? (Yes)]
Use the arrows to select a number.
Press ENTER to confi rm.
Enter the password again.