22 Installing the Scanner
Installation Procedure
The procedure for installing the unit is outlined below. (For a detailed outline
of this procedure, see “Connecting the Scanner to Your PC” at the end of this
section.)
1. Check the interface board in your computer.
(→ page 23 “Interface Board”)
↓
2. Connect the scanner to the PC.
(→ page 25 “Connecting the Scanner to your PC”)
↓
3. Connect the power cord to the scanner.
(→ page 28 “Connecting the Power Cord”)
↓
4. Turn the scanner on first, and then start up the PC.
(→ page 29 “Turning the Power On/Off”)
↓
5. Let the PC recognize the Scanner
(→ page 30 “Recognizing the Scanner”)
↓
6. Turn the scanner off. (→ page 32 “Turning the Power Off”)
To Next Page
Loading...
