147
The camera’s mechanical shake caused by the reflex mirror action can
blur images taken with a super telephoto lens or close-up (macro) lens.
In such cases, mirror lockup is effective.
Mirror lockup is enabled by setting [5: Mirror lockup] to [1: Enable]
in [54: Custom Functions (C.Fn)] (p.302).
1 Focus the subject, then press the shutter button
completely.
XThe mirror will swing up.
2 Press the shutter button completely again.
XThe picture is taken and the mirror goes back down.
After taking the picture, set [5: Mirror lockup] to [0: Disable].
Using the self-timer <Q>, <l> with mirror lockup
When you press the shutter button completely, the mirror locks up.
The picture is then taken 10 sec. or 2 sec. later.
Remote control shooting
Since you do not touch the camera when the picture is taken, remote
control shooting together with mirror lockup can further prevent
camera shake (p.309). With Remote Controller RC-6 (sold
separately) set to a 2-sec. delay, press the transmit button and the
mirror will lock up before the picture is taken 2 sec. later.
Mirror Lockup to Reduce Camera ShakeN
Shooting Tips
To Next Page
Loading...
