Canon EOS 7 - Page 153

Multiple Tool II or HS-I/F ROM
version 1.1 or later is required for
electrical adjustment of EOS 7.
If the Multiple Tool II or HS-I/F ROM
version is earlier than Ver.1.1, the
adjustment software will display the
message on the right.
If a camera other than the EOS 7.
has an unsupported ROM, this
message will appear.
6) Exiting the Adjustment Software
Be sure to end electrical adjustment by selecting F10 Quit. Selecting F10 Quit clears
the charging inhibit mode and the error number display settings, and returns the
camera to the user mode.
Part 4: Electrical Adjustment
4-5
ERRHSVER
HS-I/F ROM is not Ver. 1.1 or later.
This adjustment software runs under
HS-I/F ROM 1.1 or later.
Press any key to exit software program.
ERRCAM
The camera is not an EOS 7 2000/ 300.
This software is for the EOS 2000/ 300 only.
Press any key to exit software program.
ERRCVER
The ROM version of the connected EOS 7/ELAN7,30,33 is:
00000000000000000000
This software cannot be used to cameras with above ROM version.
Press any key to exit software program.