•
Automatic
If the left and right side of the leading edge of the roll ((a) and (b)) are uneven by 3 mm (0.12 in) or more when you
load the roll, the edge is cut an amount relative to the slant to ensure a straight edge, and scraps are removed.
The edge is not cut if the unevenness is less than 3 mm. However, paper may sometimes be cut, depending on
the state of the leading edge.This setting is Automatic for most types of paper, by default. For more information,
see the Paper Reference Guide. (See "Types of Paper.")
→P.434
•
Off
The edge is not cut and scraps are not removed.
•
On
The leading edge is cut off when you load a roll, and scraps are removed. The amount of paper cut from the lead-
ing edge varies depending on the type of paper. For more information, see the Paper Reference Guide. (See
"Types of Paper.") →P.434
Important
• If the width of the paper differs, setting Skew Check Lv. to Loose relaxes the accuracy of the paper skew detection feature,
and setting it to Off ignores the skew detection feature. However, when Off is selected and the paper is loaded skewed, a
paper jam may result or the Platen may become soiled.
Note
• In the condition at the time of factory shipment, the setting differs depending on the paper. For details, refer to the Paper
Reference Guide. (See "Types of Paper.") →P.434
Follow these steps to change the Trim Edge First setting.
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Paper tab (
).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Paper Menu is displayed.
3
Press ▲ or ▼ to select Paper Details, and then press the OK button.
iPF760
Cutting the Leading Edge of Roll Paper Automatically
User's Guide
Handling Paper Handling rolls
459
To Next Page
Loading...
Need help?
General
Weight and Dimensions
