Selecting Enable HTTPS redirection redirects the communication using CHMP to encrypted
communication.
Note
• To use CHMP for encrypted communication, you need to register the printer's root certificate to
your computer.
Registering Printer's Root Certificate to Local Computer for SSL Communication
• CHMP is a Canon proprietary protocol.
◦ Network interface settings◦
To connect to a hub that supports spanning tree, select Spanning tree settings > Enable.
Selecting Enable avoids circulating data on a network.
◦ DRX settings◦
When enabled, data is received intermittently during network connection.
◦ IP filtering◦
Allows or denies access for specific IP addresses.
Settings for both IPv4 and IPv6 addresses can be specified.
Important
• If the device address for the administrator has been set to rejection by mistake, select •
(Network) on the HOME screen of the operation panel, and then select LAN settings > Wi-Fi /
Wireless Direct / Wired LAN > Settings > Advanced > Reset LAN settings in this order, and
initialize network information of the printer.
After resetting, perform setup again as necessary.
◦ MAC address filtering settings◦
Allows or denies access for specific MAC addresses.
Important
• If the device address for the administrator has been set to rejection by mistake, select •
(Network) on the HOME screen of the operation panel, and then select LAN settings > Wi-Fi /
Wireless Direct / Wired LAN > Settings > Advanced > Reset LAN settings in this order, and
initialize network information of the printer.
After resetting, perform setup again as necessary.
◦ Reset LAN settings◦
Initializes the network settings on the printer.
After resetting, perform setup again as necessary.
457
To Next Page
Loading...
