Fax (imageRUNNER 1025iF Only)
5-54
Specifying Printing When Toner Runs Out
Specifying Printing When Toner Runs Out
You can set if the machine stores all documents in memory or continue printing without
storing documents in memory, when the toner runs out.
The default setting is <RX TO MEMORY>.
When the <TONER LOW/PREPARE NEW TONER> message appears, if you set <CONT. PRINTING> to <KEEP PRINTING>, you
can continue printing. The printed documents may be light or blurred because of lack of toner. The data is erased when
the documents are printed out, so you cannot print the same documents again.
When the <TONER LOW/PREPARE NEW TONER> message appears, if you set <CONT. PRINTING> to <RX TO MEMORY>, the
machine stores all documents in memory. After the toner cartridge is replaced, the documents can be printed and the
setting can be reset.
–
–
Press [Additional Functions].
Press [ ] or [ ] to select <TX/RX
SETTINGS>, then press [OK].
3.TX/RX SETTINGS
ADD. FUNCTIONS
Press [ ] or [ ] to select <COMMON
SETTINGS>, then press [OK].
1.COMMON SETTINGS
TX/RX SETTINGS
Press [ ] or [ ] to select <RX
SETTINGS>, then press [OK].
2.RX SETTINGS
COMMON SETTINGS
Press [ ] or [ ] to select <CONT.
PRINTING>, then press [OK].
3.CONT. PRINTING
RX SETTINGS
Press [ ] or [ ] to select <RX TO
MEMORY> or <KEEP PRINTING>, then
press [OK].
RX TO MEMORY
CONT. PRINTING
<RX TO MEMORY>: The machine stores all
documents in memory.
<KEEP PRINTING>: You can continue printing.
Press [Stop] to return to the standby
mode.
To Next Page
Loading...
Need help?
General
